01 / OFFICIAL CAMPAIGNS
2012 Hino NV8J recall campaigns
NHTSA 17V607000
- Component
- ENGINE AND ENGINE COOLING
- Report received
- September 28, 2017
- Potential units
- 3,224campaign-wide
Defect and consequence
Defect: Hino Motor Sales U.S.A., Inc. (Hino) is recalling certain 2011-2012 NE8J, NJ8J, and NV8J trucks. The engines have a wrist pin bushings in the connecting rods that may shift and cause excessive cylinder wear.
Why it matters: Excessive wear of the cylinders can result in engine failure, increasing the risk of a crash.
Remedy
Hino will notify owners, and dealers will inspect and, as necessary, replace the connecting rods. Interim notices informing owners of the safety risk were mailed November 27, 2017. The recall began on March 19, 2018. Owners may contact Hino customer service at 1-248-699-9300. Hino's number for this recall is AA860.
Owner notification: March 19, 2018 · Filing manufacturer: Hino Motors Sales U.S.A., Inc.
NHTSA 12V555000
- Component
- ELECTRICAL SYSTEM
- Report received
- December 3, 2012
- Potential units
- 35,142campaign-wide
Defect and consequence
Defect: Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing sheath.
Why it matters: If the B+ circuit shorts to ground, it may lead to a fire.
Remedy
Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.
Owner notification: January 17, 2013 · Filing manufacturer: HINO MOTORS SALES U.S.A., INC.
NHTSA 11V537000
- Component
- POWER TRAIN
- Report received
- November 3, 2011
- Potential units
- 312campaign-wide
Defect and consequence
Defect: Hino is recalling certain model 2012 nd8j, ne8j, nj8j, and nv8j commercial trucks manufactured from july 25, 2011, through september 16, 2011. during assembly, the wheel-end retainer on the front or rear axle may have been installed incorrectly.
Why it matters: The wheel-hub and axle shaft can separate from the vehicle, possibly resulting in a crash.
Remedy
Hino will notify owners, and dealers will inspect the front axle assemblies and, if the axle is found to be incorrectly assembled, dealers will replace the wheel end retaining hardware free of charge. the safety recall began on april 19, 2012. owners may contact hino at 1-248-699-9390.
Owner notification: April 19, 2012 · Filing manufacturer: HINO MOTORS SALES U.S.A., INC.
02 / COMPONENT BREADTH